StablePAVE TRADE: Typical specification
StablePAVE TRADE should be placed on a suitably compacted sub-base (see notes), with weed suppressant overlap laid underneath each following sheet.
Panels should be placed on a flat bed of blinding or sand, graded to suit the installation.
Gravel fill at a rate of 55 - 65 kg per sq. metre, should be placed into the honeycomb structure. The honeycomb structure should be overfilled to a depth of 10 - 20 mm above the top surface of the panels. Filling should take place from the access point inwards and mechanical or pedestrian traffic should only occur over filled panels. StablePAVE is suitable for use with all sizes of gravel up to 10 mm diameter.
If required final consolidation can be aided by light compaction with a compaction plate.
Sub-base substructure is dependent on the use to which the final surface is to experience. This can vary from compacted earth for very light foot access paths to 150 mm of type one sub base material, where regular vehicle traffic is anticipated. In general the same sub-base as would be specified for modular concrete paving, is applicable to StablePAVE.
StablePAVE requires virtually no maintenance.
If the honeycombs cells become exposed simply top up with gravel.
|Type||StablePAVE TRADE 30/40|
|Dimensions of the panels||1200 x 800 x 30/40 mm (L x W x H)|
|Honeycomb diameter||30 x 40 mm|
|Weight||1.59/2.45 kg/m2 (empty weight)|
|Load bearing (from)||130 tonnes/m2|
|Drainage capacity||StablePAVE TRADE is completely permeable|
|Biological resistance||Very good|
|Chemical resistance||StablePAVE TRADE (polypropylene) is resistant to almost all chemicals|